Post by michaelmorin on Jan 30, 2018 9:50:42 GMT
Hi,
I use the latest software (setup_7076.exe) and tried the Simulation Setup on my German Windows 7 installation with language in Analysis set to English. The decimal separator in Germany is ','.
After loading a run I let the software "Automatically update from data" for Acceleration, Braking and Cornering (in the "Enter a table of ..." section). The values have a ',' as the decimal separator. When I click on OK and then go back into the dialog "Simulation Setup" the values have changed to either 1 or 0 depending on if they where like 1,26 or 0,26 etc. I'm not sure if this is a rounding issue or an issue with the decimal separator but definitely the values change...
Is this a known issue?
Thanks
I didn't find the right solution from the internet.
References:
www.race-technology.com/forum/viewtopic.php?t=2088
Product Promotional Examples
I use the latest software (setup_7076.exe) and tried the Simulation Setup on my German Windows 7 installation with language in Analysis set to English. The decimal separator in Germany is ','.
After loading a run I let the software "Automatically update from data" for Acceleration, Braking and Cornering (in the "Enter a table of ..." section). The values have a ',' as the decimal separator. When I click on OK and then go back into the dialog "Simulation Setup" the values have changed to either 1 or 0 depending on if they where like 1,26 or 0,26 etc. I'm not sure if this is a rounding issue or an issue with the decimal separator but definitely the values change...
Is this a known issue?
Thanks
I didn't find the right solution from the internet.
References:
www.race-technology.com/forum/viewtopic.php?t=2088
Product Promotional Examples